Built-in Motion Sensor!
|
The amazing FloodCam is a
weather-resistant wireless video camera
with built-in 2.4GHz transmitter and motion
sensor and attached dual floodlight casing. The
FloodCam is activated by the integrated
motion sensor so that when someone
approaches your home, the floodlights (bulbs not
included) come on, turning night into day and
the camera catches the startled intruder
on video! The camera transmits its
picture via a built-in 2.4 GHz transmitter, to a
Video Receiver (not included) which you connect
to a TV anywhere in your home. The FloodCam
sends the wireless signals even through walls,
up to 100 feet so you can watch and record all
the action!
 Smart
"Built-in" Wireless Motion Sensor
The video camera always turns on when
motion is detected and the floodlights always turn on when it is dark
and motion is detected. (An X10 Transceiver is NOT necessary for this but
required for multi-camera applications.)
Multi-Camera SetUp
In a multi-camera setup, the motion sensor sends
wireless Radio Frequency (RF) signals to an X10
Transceiver (or VCR Commander II.) The
Transceiver receives the signals from the Motion
Sensor and passes them onto your house wiring.
These signals send the information back
out to turn off the other cameras or to sound a
chime, illuminate hallway lights, etc.
Easy to Use & Integrate
into Your Existing Camera System
This is a very simple system to install
- just a few connections and you're up and
running (assuming you will use the FloodCam to
replace an existing outdoor light fixture). If
there's not an existing fixture, you will need
to install a wall box and run conduit to it. If
you need help installing a wall box and running
conduit please contact a local X10 professional
installer.
You Control Everything
Underneath the FloodCam unit (shown at left) is
a hidden control panel that allows you to
easily configure all the settings. Set
the Channel to the same channel as your Video
Receiver (not included).
The FLOODLIGHT CONTROL function allows you to
detect motion at all times (LIGHT) or only when
it gets dark (DARK). Using the TIME DELAY dial,
you can adjust how long the camera waits to turn
off after motion has stopped. The CAMERA MODE
switch lets you set how the camera responds to
motion and X10 controllers. Using the two dials
at the bottom, set the camera's unit code and
house code (example A-4). Keep your cameras in
groups of four for better scanning control.
Additional Features &
Specifications:
- 2.4 GHz transmitter
- Camera uses "Instant-ON" technology. No
warm-up time when turning on or switching
between cameras. You get instant LIVE crisp
video! (X10's top of the line camera technology)
- Easily integrates into your multi-camera
system. Acts just like an XCam2 Camera!
- Weather-resistant casing. Great for
outdoors. (Operating Temp.: 32 to 131F)
- Field of View: 60 degrees
- Resolution: 310 TV Lines
- Auto Shutter: 1/60 to 1/15,000 sec. Note:
Your TV can only view 30 frames per second.
- Motion Sensor Range: 20 feet.
- Max wattage: 150W per lamp holder.
- Requires 120VAC
|
